[강의2/2] How to install Tizen IoT image on Eagleye 530s board

1
|
Last modified on July 4, 2019
Craft info.
Maker Eunyoung Lee
Status In Progress
Period 2018-08-20 ~ 2018-08-24
About This Craft
It is lecture material of Seoul IoT center.
#Eagleye530s
#Tizen
#TizenIOT
Making Note

3 thoughts on “[강의2/2] How to install Tizen IoT image on Eagleye 530s board”

  • binibini says:

    I just perfomed to download the boot firmware (Migration_artik533s_tizen_usb_recovery.tar.gz) ,the tizen bootloader (tizen-unified_20200117.3_iot-boot-armv7l-artik533s.tar.gz), and the platform image (tizen-unified_20200117.3_iot-headed-3parts-armv7l-artik530_710.tar.gz) to Eagleye530s (Artik530s + 1G or Artik533s) board.

    In the end, I setted up wifi setting for the Eagleye board and I confimed the ip address as 192.168.4.3 on my device.

    I added my remote device, eagleye530s board with ip address, 192.168.4.3 with 26101, port number to the Remote Device Manager on the tizen studio.

    However, I was able to connect my device on the Tizen studio on my Ubuntu PC.

    On the remote device manager, the error pop-up shows the following messages:

    “error: failed to connect to remote target ‘192.168.4.3’

    You may get this message for following reasons:
    – This remote device already connected by another one.
    – This remote device is running on a non-standard port.
    – There is no IP address, please check the physical connection.

    On the above, I had no reasons, I confirmed.

    Please let me know how to connect the device to the tizen studio.

Log in